What to do When Your Roof is Sagging: Car Roof Upholstery Repair

For those of us who hold on to our cars longer than they hold together, there may come a time when the roof upholstery begins to sag. Fortunately, repairing a sagging roof is much easier and cheaper to repair than replacing a transmission. Car roof upholstery repair can be done yourself with very little cost.

Step 1: Remove Elements from Roof

The first step in car roof upholstery repair is to remove all of the elements from the roof of your car in order to gain access to the upholstery. This includes removing the light fixtures, visors, and hangers. This process can be done using a screwdriver. Next, remove all of the trim around the roof upholstery using a flathead screwdriver. Only remove the parts of the trim that are directly connected to the headliner. Finally, all of the seatbelt hardware needs to be removed. Depending on the type of car, it may be necessary to use a wrench to remove the bolts.

Step 2: Remove the Headliner Board and Upholstery

The next step is to remove the headliner board from the vehicle. This step can be one of the trickiest parts of car roof upholstery repair as the board is as long as the car. Once this is taken off, begin removing the upholstery. Slowly and carefully, peel the upholstery off the roof of the car. Remember, the adhesive is probably worn off, which is the reason that the car roof upholstery repair is needed in the first place, making this step fairly easy to accomplish. It is important not to damage the foam/fabric combo, as this will be put back onto the ceiling, unless new fabric has been purchased.

Step 3: Clean and Apply Glue

The roof of your car should now be bare and the next step is to clean this area. Using an abrasive sponge and a wire brush, remove all of the dirt and debris from the roof. Make sure the entire roof is as clean as possible to make sure car roof upholstery repair will work. Once the area is clean and dry, apply upholstery glue to the entire area. Make sure to apply the glue liberally and evenly over the whole area of the roof.

Step 4: Replace the Upholstery

Carefully place the upholstery back onto the roof surface. Use both hands to press the fabric firmly and make sure there are no wrinkles or air bubbles. A ruler or yardstick can help smooth out the fabric and remove any air bubbles or wrinkles that may be in the fabric. It is important to make sure the foam/fabric composite adhere firmly and securely to the roof. Pulling the fabric to the sides will help achieve the maximum amount of tightness and prevent any future sagging.

Car roof upholstery repair is not difficult, but it is important to take your time and pay attention to the details. If the job is rushed, the roof upholstery will start sagging again and you will find yourself back in the same situation.